Self-adhesive Films

Folex Digiprint-IG/CLSA

Specially coated permanent adhesive film for Electro Ink available in Clear. The film is heat stabilized for good flatness properties and the coating offers excellent ink transfer & bonding for consistent image performance. The film has a paper silicon release liner which is removed when applying to the finished surface.

Cut sheets

Art. NumberWidth (mm)FormatLength (mm)Nominal thickness (mm)Packing quantity

Technical data


  • Superb ink adhesion and image transfer
  • Easy storage
  • Excellent dimensional stability
  • Suitable for short and long runs
  • Officially approved by HP Indigo test centre
  • Tear resistant
  • Consistent performance
  • Dedicated coating for Indigo Electro Ink
  • No limited shelf life
  • Splash resistant


  • Clear glossy


Coating PrintsideHP Indigo Electro Ink
Width (inch)12.6
Width (mm)320
PrintsideGlossy side
Adhesion strength~ 3.5 - 5.0 N / 25 mm (A.F.E.R.A.), after 24 h ~ 10 N / 25 mm (A.F.E.R.A.)
Type of adhesivedispersion
Length (inch)17.72
Length (mm)450
Nominal thickness (mil)3
Nominal thickness (mm)0.075
BacksideAcrylic adhesive with paper release liner
Temperature rangeglued +5°C up to +80°C
Total Thickness (mil)6.6
Total Thickness (mm)0.165
Base MaterialPolyester film
Packing quantity 200


  • Suitable for Digital Presses from HP Indigo
  • Not compatible with dry toner Digital Presses. (See Folex Digiprint-XE and -NX series).


  • A preconditioning period of 24 hours within the printing environment is recommended.
  • Please carefully follow the handling instructions supplied with this product as well as the press manufacturers manual.
  • No special handling required.
  • Surface Protection: The product can be used outdoor without lamination. However, the surface must be protected in order to improve weathering resistance or if the film is subject to any mechanical influences. In this case you should use self-adhesive laminating foils. If silicon oil is added depending on the type of machine this may influence the adherence of the laminating foil on the film’s surface. It is necessary to make some tests on a sample sheet before further processing.
  • Adhesive: The product will stick to any solid, smooth surfaces which are dry and free of dirt, oil, silicon etc. The temperature during the application must reach at least 15°C.
  • Avoid fingerprints on printing side.


  • Store in a cool and dry place at a room temperature of 15 - 25°C and at a humidity of 30 - 60%.

Downloads (PDF)